2004 Yamaha 70Hp 2 Stroke Not Pumping Water On Earmuffs - Boating

July 5, 2024, 7:35 am

Have I done any damage and is it ok to flush it in fresh water today? Location: Cleveland, Ohio. Tell me more, please. These aren't the kind of things you want to learn about through trial and Quadfather wrote:Thanks RCthepirate, I guess I did ask if there is anything I could do..? I can guarantee the mechanic checked the impeller, and possibly replaced it. If I get the new (to me) boat I'll see how bad the. 1998 150 Yamaha wont take water when on muffs. If the water pump fails, the engine will overheat and can be damaged beyond repair. Regular flushing with freshwater is key to maintaining any outboard motor used in saltwater. If this is the case, depending on which Mariner 15hp you have (there is the old one produced by Yamaha, the USA Model and the Tohatsu based model) you may need to consider removing the side plates (to clear out any salt) or possibly lifting the powerhead if the blockage is caused by the water-tube grommet shrinking/collapsing due to corrosion. Sinking a boat for the sake of a $50 part. "Never believe what you read on the internet"-Abraham Lincoln. Location: Cape Haze, FL. Supposedly new impeller already on, but I'm going to check on that right now.

Outboard Not Pumping Water With Earmuffs Line

If not, it's probably best to take it to a professional. Outboard motor flush ears. I use the outboard ear muffs that go over the intakes on lower unit. I don't believe you can do this on the factory fittings, but I may be wrong. So you can see it and have confidence later down the road to save some money. If you notice any of these signs, it's essential to take your outboard to a qualified marine mechanic for repair or replacement.

Outboard Not Pumping Water With Earmuffs Attached

Connect garden hose to ear muffs making sure that your hose fitting clicks on. Boaties should be aware that this is not a guarantee that the impeller will never need replacing. Engine Won't Pee in Idle- Please Help - General Forum. Is the engine over-heating? Raymarine DS600X HD Sounder. We try and maintain a five year plan. I figured there was probably damage to the impeller because of the overheating that had already been done, and when I got the boat back he said he had replaced both the impeller and housing because both were melted. A little bit of oil shouldn't be anything to worry about but if you're worried a degreaser should clean it up pretty well before filling it with water.

Outboard Motor Flush Ears

I just re-read the "Flushing the cooling system" section of my owner's. You would be amazed at the volume of water they pump. If you 're worried about it getting too warm, just take the cover off and as long as you can touch it you're fine. In additional, the noise may also propagate along your 12 Vdc. Hi, You'll need a drum to run this engine in.

If the boat is kept at a dock this type of flush connection usually can be used to flush the motor when it its tilted clear of the water. I call them mud bees. As for the hose being too small, well it looks to be at least 3/4", probably 1", so you're probably fine if it turns out that is the engine pickup. It doesn't take much of. Even less at walmart. Hopefully I've been of some help. Outboard not pumping water with earmuffs line. Sponsored by Life Proof Boats. We are dumbfounded at this point. MotorGuide 75# Thrust Wireless Bow Mount. There are a few things you can check for to see if your outboard water pump is broken. I have seen cracked caps squirting water into the.